Can brick pavers be installed over an existing concrete or asphalt driveway, patio or walk?

Brick paving can be installed over existing concrete or asphalt as long as it is in reasonably good shape. To ensure an adequate foundation for the brick, the existing concrete slab or asphalt should be inspected and repaired as necessary. Any cracks, chips, holes, ruts or spalls should be repaired in order to achieve a flat surface. The brick can be installed either with or without mortar. If no mortar is used, a half-inch setting bed of coarse sand should be laid and compacted. An edging of metal or heavy-duty plastic should be placed around the perimeter of the brickwork and set to just below the height of the finished brick surface. Pavers can then be placed in the desired pattern on top of the sand. The bricks should be placed as close to each other as possible. It may be necessary to cut some of the brick near the edging. Once the brick are all in place, install mason's sand between the brick and over the surface. Sweep away excess surface sand and the brick pavement is ready for traffic. If mortar is used, the concrete slab should be prepared in the same manner as above. A half-inch mortar setting bed should then be applied upon which the bricks are set with mortar placed between the pavers. Only a small area should receive the setting bed at a time in order to ensure that it does not set prior to laying the brick. Mortared brickwork should not be laid on asphalt. For additional information on installing pavers, see Technical Notes 14 and 14A. An online course, "Paving Training Program: Clay Pavers" is also available.